crwdns2942213:0crwdne2942213:0
-
-
Disconnect the hard drive thermal sensor from the logic board by pulling its connector toward the top edge of your iMac.
-
-
-
Remove the two T10 Torx screws securing the hard drive bracket to the inverter.
-
-
-
-
Lift the left edge of the hard drive slightly, then pull it toward the left edge of the iMac.
-
-
-
Rotate the hard drive out of the rear case.
-
Disconnect the SATA data cable by pulling its connector away from the hard drive.
-
-
-
Disconnect the SATA power cable by pulling its connector away from the hard drive.
-
Remove the hard drive from the iMac.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.