crwdns2915892:0crwdne2915892:0
Replace a broken AirPort/Bluetooth board to regain wireless connectivity.
crwdns2942213:0crwdne2942213:0
-
-
Orient the iMac face-side down on a table with the bottom edge facing yourself.
-
Remove the two Phillips screws securing the access door to the bottom grille of your iMac.
-
-
-
Remove the three T8 Torx screws securing the front bezel to the rear case along the lower edge of the iMac.
-
-
-
Turn the computer over.
-
Use your thumbs to press both RAM arms in past the front bezel for enough clearance to lift it off the rear case.
-
-
-
While holding the RAM arms in with your thumbs, lift the lower edge of the front bezel enough to clear the rear case.
-
-
crwdns2935267:0crwdne2935267:0Plastic Cards$2.99
-
Insert a plastic card up into the corner of the air vent slot near the top of the rear case.
-
Push the card toward the top of the iMac to release the front bezel latch.
-
Pull the front bezel away from the rear case.
-
Repeat this process for the other side of the front bezel.
-
If the bezel refuses to release, try pressing the lower edge back onto the rear case and repeat this opening process.
-
-
-
-
Lay your iMac stand-side down on a table.
-
Lift the front bezel from its lower edge and rotate it away from the rest of your iMac, minding the RAM arms that may get caught.
-
Lay the front bezel above the rest of the iMac.
-
-
-
If necessary, remove the piece of kapton tape wrapped around the microphone and camera connectors.
-
-
-
Disconnect both the camera and microphone cables.
-
-
-
Peel the lower EMI shield off the lower edge of the iMac and off the two vertical 4" sections on either side of the iMac.
-
-
-
Tape the lower EMI shield up against the face of the display to keep it out of the way while you work.
-
-
-
Remove the single T10 Torx screw securing the right speaker to the rear case.
-
-
-
Lift the right speaker out of the rear case.
-
-
-
Remove the two Phillips screws securing the AirPort/Bluetooth board to the logic board.
-
-
-
Use your finger to lift the AirPort/Bluetooth board from its left edge, disconnecting it from the logic board.
-
-
-
Use the flat end of a spudger to pry both antenna connectors up off the AirPort/Bluetooth board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Does any one else notice this isn't a g5? Its a 20" intel