crwdns2915892:0crwdne2915892:0
You will be replacing the entire disk drive in your radio, the only special tool that is needed for this replacement are the iOpener or heat gun because of the adhesive.
crwdns2942213:0crwdne2942213:0
-
-
Make sure you remove all seven 3 mm screws before proceeding to the next step.
-
-
-
Use iOpener or heat gun on all sides except the front.
-
-
-
-
Be cautious when taking the top of the device off there may still be some adhesive stuck to device.
-
-
-
Remove all four screws(13.5 mm in length) that are securing the device
-
-
-
Remove both of the connected cords on the motherboard.
-
Also remove the flat ribbon cable that is connected to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.