crwdns2915892:0crwdne2915892:0
This guide shows how to open the bottom of the iHome iAVS16 to gain access to the board housing the AC power and USB jacks.
Since the iHome iAVS16 is a compact device, any following replacement guide will use this guide as well in order to access the rest of the device.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four 1.7 mm Phillips #0 screws located on the bottom of the device.
-
Lift up the bottom of the device.
-
-
-
Remove the two 1.7 mm Phillips #0 screws holding the white face place onto the inside of the device's bottom.
-
Using an iFixit opening tool on the side without the black adhesive, carefully lift up the white face plate.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the tweezers, lift up on the black tab holding the ribbon cable down.
-
Carefully pull the ribbon cable back and out of the slot.
-
-
-
Remove the two 1.7 mm Phillips #0 screws holding the power board in.
-
Carefully flip the board over.
-
Remove the red connector from its socket with a pair of tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.