crwdns2915892:0crwdne2915892:0
Use the following steps to replace an individual speaker out of the iHip Fold-up Portable Speaker. The issue usually arises from a speaker with distorted audio.
crwdns2942213:0crwdne2942213:0
-
-
Use your fingers to slide the battery case cover off in the direction of the arrows.
-
-
-
Remove the four AAA batteries. Be sure to check your nearest battery recycling point!
-
-
-
-
Unscrew the four outer 1.0 mm screws with a Phillips-Head screwdriver.
-
Push down gently on the battery case cover and slide it in the direction the arrows indicate. Remove the batteries.
-
Unscrew the 0.6 mm screw located in the center of the battery case.
-
Keep the 1.0 mm and 0.6 mm screws separate from each other for reassembly.
-
-
-
Remove the back cover carefully; there are many wires that connect it to the device.
-
-
-
Locate the two individual speakers on either side of the front cover.
-
-
-
Use a plastic opening tool to scrape off the glue around the speakers.
-
Gently pull the speaker up to detach it from the front cover.
-
Desolder the black and red wires from the speaker unit.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Clemson, Team 3-4, Benson Fall 2014 crwdns2935289:0Clemson, Team 3-4, Benson Fall 2014crwdne2935289:0
CLEM-BENSON-F14S3G4
crwdns2931471:05crwdne2931471:0
crwdns2935297:08crwdne2935297:0
