crwdns2915892:0crwdne2915892:0
This guide will walk you through how to replace the motherboard of the iHip Fold-Up Portable Speaker.
crwdns2942213:0crwdne2942213:0
-
-
Place the device on a flat surface as shown.
-
Remove the battery case cover and batteries.
-
-
-
Using a Phillips-Head #1 screwdriver, unscrew the four outer 1.0 mm screws and remove with tweezers.
-
Unscrew the 0.6 mm screw located in the center of the battery case.
-
Remove the back cover carefully; there are many wires that connect it to the device.
-
-
-
-
Using a Phillips-Head #1 screwdriver, carefully unscrew all three 0.4 mm screws from the indicated locations. Set aside for reassembly.
-
Using tweezers, gently remove the motherboard from the back cover of the device.
-
-
-
Using utility scissors, cut all the wires connecting the motherboard to the device.
-
Using tweezers, place the new motherboard in the exact position of the old motherboard.
-
-
-
Position a strip of solder at the point of contact between the motherboard and each individual wire.
-
Solder the wires to the motherboard. Make sure to follow the manufacturer's instructions, as well as general soldering safety principles.
-
-
-
Using a Phillips-Head #1 screwdriver, screw the original 0.4 mm screws into the correct places to secure the motherboard back in place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Clemson, Team 3-4, Benson Fall 2014 crwdns2935289:0Clemson, Team 3-4, Benson Fall 2014crwdne2935289:0
CLEM-BENSON-F14S3G4
crwdns2931471:05crwdne2931471:0
crwdns2935297:08crwdne2935297:0
