crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

LeapFrog LeapPad 2 Rear Cover Replacement

crwdns2936025:01crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2931533:0crwdnd2931533:0crwdnd2931533:0crwdnd2931533:07crwdnd2931533:0crwdne2931533:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Use a Phillips #1 screwdriver to remove the following screws from the device:

Four 7.0mm Phillips screws

Three 6.0mm Phillips screws

Two 10.0mm Phillips screws

These two screws are behind the barcode decal on the bottom of the device. Expose the screws by puncturing, cutting, or peeling the barcode decal.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0