crwdns2894164:0crwdne2894164:0
crwdns2894186:0crwdne2894186:0
crwdns2875948:07crwdne2875948:0 —

crwdns2873952:0crwdnd2873952:0crwdnd2873952:0crwdnd2873952:014crwdnd2873952:0crwdne2873952:0

crwdns2869020:0crwdne2869020:0:

crwdns2858926:0crwdne2858926:0

Remove the following screws securing the logic board to the case:

One 2.5 mm Phillips screw near the vibrator motor

One 2.4 mm Phillips screw

One 3.6 mm standoff along the side of the logic board nearest the battery opening.

Use a standoff driver bit and driver handle to remove the single 3.6 mm standoff screw.

In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0