crwdns2894164:0crwdne2894164:0
crwdns2894186:0crwdne2894186:0
crwdns2875948:011crwdne2875948:0 —

crwdns2873952:0crwdnd2873952:0crwdnd2873952:0crwdnd2873952:014crwdnd2873952:0crwdne2873952:0

crwdns2869020:0crwdne2869020:0:

crwdns2858926:0crwdne2858926:0

Remove the following 8 screws:

Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

Note for re-assembly:

The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0