Unplug the three plastic connectors on the left side of the PCB board.

Unplug the two plastic connectors on the top of the PCB board.

Unplug the three plastic connectors on the right side of the PCB board.

Pulling the plastic connectors requires a lot of force, but be careful and don't pull directly on the wires. Try to wedge or push the male side of the connector out.

If you need some extra leverage when removing these connectors, try using a plastic opening tool to pry off the connectors.

Removing these connectors allows easier access to the four screws attaching the PCB board mount to the motor housing.