crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Disassembling Ninja NJ600 Blender Base Cover

crwdns2936025:03crwdne2936025:0 —
crwdns2916944:0crwdne2916944:0

crwdns2931533:0crwdnd2931533:0crwdnd2931533:0crwdnd2931533:05crwdnd2931533:0crwdne2931533:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.

Be careful not to damage the two wires that are keeping this third layer attached to the base.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0