crwdns2894164:0crwdne2894164:0

crwdns2890822:0crwdne2890822:0

crwdns2890844:0crwdne2890844:0

crwdns2861143:0crwdne2861143:0

crwdns2894186:0crwdne2894186:0
crwdns2875948:03crwdne2875948:0 —

crwdns2873952:0crwdnd2873952:0crwdnd2873952:0crwdnd2873952:03crwdnd2873952:0crwdne2873952:0

crwdns2869020:0crwdne2869020:0:

crwdns2858926:0crwdne2858926:0

To reinstall the X clamp, first start by attaching two corners to the posts on the heat sink.

While holding the third arm of the X clamp down against the post attached to the heat sink, use a small flathead screwdriver to pry the X clamp away from the heat sink post.

As you pry, press down on the arm of the X clamp until you "walk" it down into the retaining groove cut into the post attached to the heat sink.

Repeat this process for the fourth arm of the X clamp.

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0