crwdns2894164:0crwdne2894164:0
crwdns2894186:0crwdne2894186:0
crwdns2875948:07crwdne2875948:0 —

crwdns2873952:0crwdnd2873952:0crwdnd2873952:0crwdnd2873952:011crwdnd2873952:0crwdne2873952:0

crwdns2869020:0crwdne2869020:0:

crwdns2858926:0crwdne2858926:0

Remove the following five screws securing the Wi-Fi antenna to the logic board:

One 2.3 mm Phillips

Two 1.6 mm Phillips

One 1.4 mm Phillips

One 4.8 mm Phillips

When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless.

Also make sure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad Wi-Fi reception after reassembly.

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0