Once the solenoid has been successfully replaced. Plug in your chosen OBDII tool into the port located below the steering column and slightly to the left. (See photos). Turn the key to accessory and use your tool to clear the code!

Once you have cleared the code, start the engine to make sure the new part is good. Turn off your engine.

You can now check your front brake wear. Clean and spray up any rust, replace broken or missing plastic push clips. On steel wheels, you may want to spray over any rust on the inside of the wheel where it mounts. Clean and put grease around the centre that passes through the rotor, and apply anti-seize compound to the threads of the wheel lugs.