Use a T5 Torx screwdriver to remove the two 5 mm‑long screws securing the USB-C ports.

These screws may be hard to access. If you can't insert your screwdriver properly, use a flexible extension to avoid stripping screws or damaging the logic board.

During reassembly:

Partially tighten the two screws securing the top of the ports.

Put the USB-C bracket into place and partially tighten the screw that secures it.

Lay your Mac Studio down and plug a cable into each port to ensure proper fit and alignment, adjusting the ports as necessary—the cables should be easy to insert and remove.

With both cables plugged in and the ports in position, fully tighten all three screws.

Unplug any cables before continuing reassembly.