crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0
crwdns2918538:0crwdne2918538:0

Makita Jack Hammer HM1203C 2010 Bolt Holder Service

crwdns2936025:07crwdne2936025:0 —
Remove the bolt

crwdns2931533:0crwdnd2931533:0crwdnd2931533:0crwdnd2931533:04crwdnd2931533:0crwdne2931533:0

crwdns2935477:0crwdne2935477:0:

crwdns2935483:0crwdne2935483:0

Use a long punch, long flathead screwdriver, or a thin, long bar to push the bolt out of the bolt holder.

Remove the bolt.

During reassembly, make sure all the seals on the bolt stay seated properly while you slide the bolt back into the holder.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0