crwdns2915892:0crwdne2915892:0
The Power Board is the board that charges the PS Move controllers. This is how you replace it.
crwdns2942213:0crwdne2942213:0
-
-
Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
-
-
-
Remove the six 2 mm PH0 screws on the bottom of the device.
-
-
-
Gently remove the bottom of the device.
-
-
-
-
Remove the four 1.8 mm J1 screws.
-
Remove the two 2mm PH0 screws.
-
-
-
Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
-
-
-
Remove the four 1.8 mm PH0 screws that are holding the board in.
-
-
-
Using a plastic opening tool or a similar tool, gently pry the power ribbon cord out of its port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0