crwdns2915892:0crwdne2915892:0
While the LEDs should not interfere with the function of the Quad Dock, it is nice to see them work. Find out how to replace them.
crwdns2942213:0crwdne2942213:0
-
-
Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
-
-
-
Remove the six 2 mm PH0 screws on the bottom of the device.
-
-
-
Gently remove the bottom of the device.
-
-
-
-
Remove the four 1.8 mm J1 screws.
-
Remove the two 2mm PH0 screws.
-
-
-
Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
-
-
-
Desolder the two points following the instructions included in your soldering kit as you remove the light.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0