crwdns2915892:0crwdne2915892:0
This is where all of the power comes into the device. Learn how to replace it. Be careful while soldering!
crwdns2942213:0crwdne2942213:0
-
-
Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
-
-
-
Remove the six 2 mm PH0 screws on the bottom of the device.
-
-
-
Gently remove the bottom of the device.
-
-
-
-
Remove the four 1.8 mm J1 screws.
-
Remove the two 2mm PH0 screws.
-
-
-
Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Locate the three solder connections for the electrical port.
-
Desolder the connection points following the instructions included with your soldering kit as you remove the port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0