crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Michael Blumcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Michael Blum

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Use the heat gun to loosen the adhesive around the perimeter of the screen(the solid black section).
[* black] The spudger tools can then be slowly worked under the screen and gradually lift it away from the case.
-[* icon_caution] Due to the close proximity of the digitizer if that is not being replace be very careful not to scratch the screen with the spudger.
-[* icon_caution] Do not recommend starting at the top of the screen where the logo is. Under this section there is a copper strip that we found easier to get under by tackling that section last.
+[* icon_caution] Due to the close proximity of the digitizer to the adhesive, if that component is not being replaced take care not to scratch the screen with the spudger.
+[* icon_caution] Under the top section where the Lenovo logo is lies a copper strip that has adhesive on both sides. It is easiest to get under that strip when you start from the bottom and work up.
[* icon_note] Next step will show the copper strip.