crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0David Hodsoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Hodson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* blue] Move the stationary probe to the ring terminal and repeat the previous procedure to identify the ring connector.
[* black] The remaining connector corresponds to the sleeve. In this case, it is the longest connector.
-[* yellow] Slide the sleeve over the cable to be soldered. Make sure that it is on with the large opening to the wire end.
-[* black] To assist with the soldering of the small wires, a tool like this third hand is a big help, but not a necessity.
+[* yellow] Slide the plastic sleeve over the headphone cable. Make sure that it is installed with the larger opening to the wire end.
+[* black] To assist with soldering the small wires, a tool like this third hand is a big help, but not a necessity.