crwdns2933803:04crwdne2933803:0
crwdns2933797:0Hannah Mullinscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Fold the strap so there is a half-inch between the stitching line and the handle attachment. | |
| - | [* black] After you have threaded the needle, begin sewing the end of the strap to itself. Start at one end and move to the other as you sew. |
| - | [* black] Sewing: push the needle through both straps starting on one side. Then go underneath the stitch and come back through the strap. Repeat this until you have sewed a stitch across the entire width of the strap. Then tie a knot at the end and push the needle through one final time. Cut excess string. |
| + | [* black] After you have threaded the needle, begin sewing the end of the strap to itself. |
| + | [* black] Start on one edge and push the needle through both piece of strap. |
| + | [* black] Once the bit of thread is pulled through, go through the strap again, this time a pinch to the side of where you came up. |
| + | [* black] Repeat this until you have sewed a stitch across the entire width of the strap. |
| + | [* black] After reaching the opposite end, pull the needle through, bringing up as much excess thread as it allows. Note: do not pull too hard or the thread will rip. |
| + | [* black] Tie a knot at the end, keeping the knot close to the base of the thread. Repeat until you believe the knot is strong enough to hold. |