crwdns2933803:04crwdne2933803:0
crwdns2933797:0Mikey Marquisscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mikey Marquiss
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] If the connections in the preceding step are good, check the connection of the wires to the circuit board. | |
| - | [* black] Make sure you check the correct solder as the wires are routed differently. The blue |
| + | [* black] Make sure you check the correct solder as the wires are routed differently. The blue arrow shows where the wires enter the circuit board. The black circle shows where the black wire is soldered to the board and the red circle shows where the red wire is soldered to the board. |
| [* black] If any of the connections are loose or damaged, the blender might not be getting power. | |
| [* black] Re-solder the connections using this [guide|750|iFixit Soldering guide] |