crwdns2933803:01crwdne2933803:0
crwdns2933797:0Sahil Sharmacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sahil Sharma
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Use a Phillips #1 screwdriver to loosen the four (4) large silver screws evenly in the order of the numbers engraved next to each screw. | |
| - | [* orange] Use a Phillips # 0 to loosen the other four (4) |
| + | [* orange] Use a Phillips # 0 to loosen the other four (4) 2.4 mm screws evenly in the order engraved on the copper next to each screw. |
| [* black] Repeat the last two bullets until all the larger silver screws make a clicking sound and the 2mm screws are removed. | |
| [* icon_note] The silver screws cannot be completely removed. | |
| [* black] Peel away the black tape between the RAM shield and the heat sink. | |
| [* icon_reminder] When reattaching the heat sink to the motherboard, make sure to tighten the screws a little bit at a time, in the same order as before, until they are all snug. |