crwdns2933803:010crwdne2933803:0
crwdns2933797:0Walter Galancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Walter Galan
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Place the replacement cable in place and align the far right contact with the far right solder point. Use |
|---|---|
| + | [* black] Place the replacement cable in place and align the far right contact with the far right solder point. Use two small strips of electrical tape to hold the cable against the solder pads. |
| [* black] Place two strips of tape over the end of the ribbon cable to both cover the two left-most solder pads and hold the contacts down against the logic board. | |
| [* black] Heat the right-most contact until the solder below melts, then apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board. | |
| [* icon_caution] Do not apply too much solder. The amount required for a proper bond is miniscule. | |
| [* black] As soon as the solder has flowed into the joint, remove both the solder and the iron. | |
| [* black] Repeat this process with the second solder pad. |