crwdns2933803:010crwdne2933803:0
crwdns2933797:0Jake Devincenzicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jake Devincenzi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place the replacement cable in place and align the far right contact with the far right solder point. Use 2 small strips of electrical tape to hold the cable against the solder pads. |
|---|---|
| + | [* black] Place two strips of tape over the end of the ribbon cable to both cover the two left-most solder pads and hold the contacts down against the logic board. |
| + | [* black] Heat the right-most contact until the solder below melts, then apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board. |
| + | [* icon_caution] Do not apply too much solder. The amount required for a proper bond is miniscule. |
| + | [* black] As soon as the solder has flowed into the joint, remove both the solder and the iron. |
| + | [* black] Repeat this process with the second solder pad. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0