crwdns2933803:07crwdne2933803:0
crwdns2933797:0drmdolfancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 drmdolfan
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] PCB and Camera Module |
|---|---|
| + | [* black] The only thing holding the camera to the board at this point is another flexible printed circuit cable with some adhesive on the connector and hold down. |
| + | [* black] This time I started from the connector end and carefully but with pressure used my 1.0 flathead bit to cleanly scrape off the goo. |
| + | [* black] Flip up the connector hold down "latch" with a spudger or the flathead bit and remove the flex cable and pull the camera module out. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0