crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Scott Havardcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Scott Havard

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] If necessary, reheat your iOpener and lay it over the top edge of the device. Wait a couple minutes for the adhesive to soften.
+[* black] Reheat your iOpener and lay it over the top edge of the device. Wait a couple minutes for the adhesive to soften.
[* black] Once the front panel is adequately heated, insert the blade of a halberd spudger next to the opening pick from the previous step.
-[* black] Slide the blade between the display assembly and rear case, stopping in the center of the top edge.
+[* black] Slide the blade towards the along the top edge of the iPad, stopping before reaching the front-facing camera.