crwdns2936039:0How to Monster iBeatscrwdnd2936039:03crwdne2936039:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Purucrwdnd2933797:0Kho 14, 2012crwdne2933797:0

: crwdns2933769:0crwdne2933769:0
: crwdns2933771:0crwdne2933771:0
: crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-	[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off. Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. ~~This helps the over exposed wire been covered intensionally. Now that the most difficult part has been done, it's time to push the jack into the iBeats metal exterior.~~ You may spray non conductor material or just simply use clear tape to pr
+	[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off. Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. You may spray non conductor material or just simply use clear tape to avoid short circuit. Now push the jack into the iBeats metal exterior spraying quick dry fixer. Then push the rubber cable support the same way.

[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off. Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. ~~This helps the over exposed wire been covered intensionally. Now that the most difficult part has been done, it's time to push the jack into the iBeats metal exterior.~~ You may spray non conductor material or just simply use clear tape to pr

[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off. Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. You may spray non conductor material or just simply use clear tape to avoid short circuit. Now push the jack into the iBeats metal exterior spraying quick dry fixer. Then push the rubber cable support the same way.