crwdns2933803:03crwdne2933803:0
crwdns2933797:0abhishek jcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 abhishek j
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] CLEENING WITH NEEDLE |
|---|---|
| + | [* red] Take the needle, and try to clean it from the top of the nozzle block. |
| + | [* orange] In some case, jammed filament will not come out free. At this case , increase the nozzle temperature to 280deg and remove the nozzle cooler fan. |
| + | [* yellow] And try to clean the nozzle from the top with the help of a needle and a nose plier. |
| + | [* green] If the nozzle is again not clean, try to clean the nozzle by removing the nozzle tip with the help of a nose plier and spanner. Again clean it with the help of a needle. |
| + | [* black] NOTE: Be careful while removing the nozzle tip. If you extract more pressure on the nozzle tip, it may break. So be careful while doing it. |