crwdns2933803:06crwdne2933803:0
crwdns2933797:0Jeremy Duhecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeremy Duhe
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Insert the shaft |
|---|---|
| + | [* black] Slide the shaft in, small end first, until it just protrudes from bearing on the gear side. |
| + | [* black] Hold the pinion gear in place and slide the shaft the remainder of the way into it. |
| + | [* icon_note] Make sure the shaft is flush with the back of the machine and the pinion gear is on as far as it will go. |
| + | [* black] Tighten the set screws on the gears (there are 2 on the pinion). |
| + | [* icon_reminder] Nylon gears are supposedly self lubricating but I find a little sewing machine oil is useful since it is driven by a worm gear. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0