crwdns2933805:0crwdne2933805:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] In the following steps you will be cutting through the adhesive around the edge of the rear glass panel. |
|---|---|
| + | [* black] The adhesive on the rear case is laid out as seen in the first image. |
| + | [* black] The prying pattern as seen from the outside of the phone is as follows: |
| + | [* red] Thick portions of adhesive |
| + | [* orange] Thin areas of adhesive |
| + | [* yellow] Avoid prying here, to protect the fingerprint sensor. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0