crwdns2933803:011crwdne2933803:0
crwdns2933797:0Brett Harttcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brett Hartt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Start leaning the logic board back into the iMac. |
|---|---|
| + | [* red] Route the SATA data cable underneath the edge of the metal plate behind the logic board. |
| + | [* orange] Continue routing the SATA cable up through the cable slot in the plastic frame. |
| + | [* yellow] Finish routing the SATA cable though the cutaway in the plastic frame near the optical drive, just below the GPU heat sink. |
| + | [* icon_note] The SATA data cable should be laid over the SATA power cable that is already routed through this cutaway. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0