crwdns2933803:02crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Removing screen | |
| - | [* black] Using the sharp implement, VERY carefully move around the edge of the glass screen and prise the screen up out of the case (Note you start cutting vertically between the black screen and the thin white border - you do NOT cut on the side between the rubber and the plastic) |
| + | [* black] Using the sharp implement, VERY carefully move around the edge of the glass screen and prise the screen up out of the case. |
| + | [* icon_note] Start cutting vertically between the black screen and the thin white border—do NOT cut on the side between the rubber and the plastic. |
| [* black] You'll probably need to go around the edge of the Garmin a few times before it comes totally free | |
| [* black] There is double sided adhesive holding the screen to the case, and you just need to break that seal to get the screen out | |
| [* black] Be VERY careful you don't push your sharp implement too far into the device, as there is a delicate connector near the bottom right hand corner that you could damage | |
| [* black] Once you have broken the seal all the way around the perimeter, the screen should just lift off |