crwdns2933803:08crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Slide the blade of a halberd spudger into the opening on the edge of the rear button bracket. |
|---|---|
| + | [* icon_caution] Careful not to push directly against the rear button ribbon cable, to avoid damaging it. |
| + | [* icon_caution] Do not push the spudger in too far, to avoid damaging the rear button. |
| + | [* black] Continue sliding the spudger blade around the base of the bracket to cut all the adhesive holding the bracket to the rear case. |
| + | [* black] Remove the bracket. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0