crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] In the following steps you will be cutting through the adhesive around the edge of the rear glass panel.
-[* black] Areas of interest are as follows.
- [* red] Areas of adhesive (in addition to the adhesive on the edge of the rear case).
+[* black] In the following steps you will be cutting through the adhesive on the rear glass panel.
+[* black] Take note of the following areas:
+ [* red] In addition to cutting around the edge, there is extra adhesive here that should be cut.
[* orange] Avoid sticking the spudger blade in too far here, to avoid damaging the rear button ribbon cable and chip.