crwdns2933803:015crwdne2933803:0
crwdns2933797:0Paul Barnfathercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul Barnfather
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Refit mainshaft and clutch actuator | |
| [* black] Fit a new mainshaft bearing. | |
| [* black] Fit first and second gear to the mainshaft, fit the mainshaft into the bearing and do up the the nut ***very*** tight. | |
| [* icon_note] Use thread lock to make sure the mainshaft nut cannot come undone. | |
| [* black] Fit the clutch actuator alignment pin (or screw). | |
| [* black] Check the pin through the clutch actuating lever is secure. | |
| - | [* black] Fit the clutch actuator, aligning it with the pin in the housing and not forgetting the 3/8" ball underneath. |
| + | [* black] Fit the clutch actuator, aligning it with the pin in the housing and not forgetting the 3/8" ball underneath. Add a dab of grease to the ball, as the actuator sits above the gearbox oil level. |
| [* black] Do up the clutch actuator retaining ring. It is difficult to get it tight using a C-spanner. |