crwdns2933803:015crwdne2933803:0
crwdns2933797:0Paul Barnfathercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul Barnfather
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Refit the kickstart pawl and mainshaft | |
| [* black] Fit the kickstart pawl so that the return spring is tensioned by approx. 90º. | |
| [* black] Fit a new mainshaft bearing and do up the the mainshaft nut very tight. | |
| [* icon_note] Use thread lock to make sure the mainshaft nut cannot come undone. | |
| [* black] Fit the clutch actuator alignment pin (or screw). | |
| - | [* black] Fit the clutch actuator, aligning it with the pin and not forgetting the 3/8" ball underneath. |
| + | [* black] Check the pin through the clutch actuating lever is secure. |
| + | [* black] Fit the clutch actuator, aligning it with the pin in the housing and not forgetting the 3/8" ball underneath. |
| [* black] Do up the clutch actuator retaining ring. It is difficult to get it tight using a C-spanner. |