crwdns2933803:09crwdne2933803:0
crwdns2933797:0Paul Barnfathercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul Barnfather
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the clutch actuator and mainshaft | |
| [* black] The clutch actuator is held in place with a threaded ring. Ideally, you would use a C-spanner to remove it, but access is so restricted that you will probably need to use a drift and hammer... | |
| + | [* icon_caution] Watch out for the 3/8" ball under the clutch actuator. |
| [* black] There should be a pin or screw to align the clutch actuator. If it is in the way of the mainshaft bearing, you will need to remove it. An impact driver may be necessary. | |
| [* black] Now you can undo the nut on the end of the mainshaft and tap out the bearing. | |
| [* icon_caution] The nut on the end of the shaft may be extremely tight. Clamp the shaft firmly in a soft-jawed vice and use a power bar to undo it. |