crwdns2933803:05crwdne2933803:0
crwdns2933797:0Paul Barnfathercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul Barnfather
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Rebuild the casing |
|---|---|
| + | [* black] Start with a clean casing as shown. |
| + | [* black] Pop the casing in an oven at approx 150ºC. Put the main bearing and layshaft bush in the freezer. |
| + | [* black] The bearing and bush should both drop into the casing (or go in with a light tap). |
| + | [* icon_note] Use Loctite 603 to fix the layshaft bush in place. |
| + | [* icon_note] If you have the later type of casing with a locating hole for the layshaft bush, make sure the machined recess in the bush lines up with the hole as shown here. |
| + | [* icon_caution] Check that the face of the layshaft bush is proud of the casing. Some replacement layshaft bushes are too thin and will cause the layshaft gear to touch the casing. |
| + | [* black] Put some thread lock onto the thread of the selector pivot shaft and screw it in firmly. |
| + | [* black] Don't put the plunger bolt in yet; that comes later. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0