crwdns2933803:04crwdne2933803:0
crwdns2933797:0Paul Barnfathercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul Barnfather
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Strip down the main casing | |
| [* black] Gently tap out the main oil seal with a suitably-sized socket or drift. | |
| - | [* black] If you plan to replace the main output bearing, you can also tap this out with a socket or drift; it |
| + | [* black] If you plan to replace the main output bearing, you can also tap this out with a socket or drift; it should come out easily. |
| [* black] Drift out the steel plug covering the layshaft bush and drift the bearing out (if it hasn't fallen out already). | |
| [* black] Unscrew the detent plunger housing bolt. | |
| [* icon_caution] Note this bolt may be incredibly tight. If it's stuck, apply a bit of gentle heat to the casing and use a power bar and a good-quality wall-drive 21mm socket to remove it. | |
| [* black] There's probably no need to remove the gear selector bush, as it's unlikely to be worn. | |
| [* black] Wash the casing out with paraffin or degreaser. |