crwdns2933803:06crwdne2933803:0
crwdns2933797:0Philip Le Richecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Le Riche
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Lift off the metal cover, gently releasing the clips on the sides and the front, and easing it over the sockets at the back. |
|---|---|
| + | [* icon_note] This metal cover is flimsy and easily bent. Try not to bend it, but if you do (which is likely), be sure to bend it back. |
| + | [* orange] Gently pull the ribbon cable by the optical assembly out of its socket. |
| + | [* red] Disconnect 7 other cables. |
| + | [* icon_caution] DO NOT disconnect the cables by pulling on the wires, but rather ease the plugs out of their sockets. They will come out quite easily if you repeatedly pull on one side then the other, or grip them with a good quality pair of tweezers. |
| + | [* black] You can now lift off and put aside the main logic board by easing it upwards from the front. When you get it off you will see that it was retained by 2 connectors: an edge connector on the optical assembly and a pin block to the right connecting it to the power supply board below. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0