crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0machv5crwdnd2933797:0crwdne2933797:0

crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 David Hodson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use a spudger to disconnect ribbon cable(s) 1, 2, and 3.
-[* black] Just a reminder. The 3rd cable is actually connected to the board by a port, which requires an inset connector.
-[* icon_reminder] Lift up the black tab on the back of the inset connector port, and then the 3rd ribbon should slide right out.
+[* black] Use a spudger or 'Open Pry tool' to disconnect the molex connectors for the LCD & Digitizer flexcable(s) #1 & #2.
+[* black] There is another cable underneathe the first two molex connectors that is secured by a jawbone connector. gently pry up from the system board. When don correctly it will fold in half. You don't need a lot of force to do this. And be careful not to pry the whole assembly from the board. This can happen quite easily.
+[* icon_reminder] Lift up the black tab on the back of the jawbone connector port, and then the 3rd ribbon should slide right out. Note: make sure that the jaw is in the upwards position when reassembling or the cable will not be able to seat properly.