crwdns2933803:02crwdne2933803:0
crwdns2933797:0antispamdhcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jake Devincenzi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Carefully lay the iMac stand-side down on a flat surface. | |
| [* icon_note] Due to tight tolerances, you will have to use a thin hooked tool to lift the display out of the outer case. As seen in the third picture, we made one out of a bent paperclip. | |
| - | [* black] Use a thin hooked tool to lift one side of the |
| + | [* black] Use a thin hooked tool to lift one side of the TOP edge (picture is upside down) of the display by its steel outer frame. |
| [* icon_note] After lifting the top edge of the display on one side, hold it out of the outer case while you use a hooked tool to lift the other side. | |
| [* icon_caution] Do not lift the top edge of the display out of the outer case too far, as several short ribbon cables still connect the two components. |