crwdns2933803:04crwdne2933803:0
crwdns2933797:0Taylor Dixoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Taylor Dixon
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Wedge an opening tool into the notch that is located at the bottom right corner of the phone. |
|---|---|
| - | [* black] Slide the opening tool across the bottom and up the left side of the device and lift the mid-frame. This is to avoid the ribbon cable center top. |
| - | [* icon_note] Hearing clicks as you lift the mid-frame off is normal because of the clasps holding it down. |
| - | [* icon_note] If the clasps fail to come undone, try pushing the edge you're working on inwards to loosen them up. |
| - | [* icon_caution] When lifting the mid-frame, be careful not to damage the ribbon cable connecting the earpiece speaker to the motherboard. |
| + | [* black] Slide the opening tool up both sides of the device in the small space between the midframe and the rear case to release the clips holding it in place. |
| + | [* icon_note] Note that the clips do not release by sliding ''through'' them, but rather the inward pressure the opening tool creates as it enters the gap ''around'' them. |
| + | [* icon_note] If the clasps fail to come undone, try pushing the edge you're working on inward with your hand. |
| + | [* icon_caution] Do not attempt to remove the midframe yet! There is still a fragile ribbon cable underneath connecting the earpiece speaker to the motherboard. |