crwdns2933805:0crwdne2933805:0
crwdns2933797:0Jared Matthewscrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Place the battery in the rear panel with the cable side down. Use two small strips of electrical tape to hold down the cable against the solder pads. |
|---|---|
| + | [* black] Place the new battery in the rear panel with the cable side down. Use two small strips of electrical tape to hold down the cable against the solder pads. |
| [* black] Place a strip of tape over the end of the battery ribbon cable to cover two of the solder pads and hold the contacts down against the logic board. | |
| [* black] Heat the rightmost contact until the solder melts. Apply a small amount of solder to the contact. Allow it to flow through the two holes in the cable and down to the logic board. | |
| - | [* |
| - | [* |
| + | [* icon_caution] Do not apply to much of the solder. |
| + | [* icon_caution] Remove both the solder and the iron as soon as the solder has flowed into the joint. |