crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Richardcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Unscrew the four the mm Phillips #1 screws on the bottom of the stand using the J00(t) magnetized screwdriver.
-[* black] With a blue opener tool pry open the bottom of the stand from the top.
-[* black] If having a hard time separating the two pieces use the "eye opener" tool.
+[* black] Unscrew the four screws on the bottom of the stand with a J00 screwdriver.
+[* black] Use a plastic opening tool to pry open the bottom of the stand.
+[* black] If having a hard time separating the two pieces use the iOpener tool to soften the adhesive under the panel.
[* black] Heat up for 30 seconds. Once it is hot place around the stand to loosen the glue.