crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Hephaestus Engineeringcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Hephaestus Engineering

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Loosening the electronics
[* black] Flip the guitar up side down and locate the electronics cavity.
-[* black] Create slack in the wires by using wire cutters to cut the tie wrap binding the wires together.
-[* icon_caution] Take special care to avoid the wires when cutting the tie wrap or moving the wiring around. Replacing the wiring of the guitar is not included in this manual.
-[* black] Pull the potentiometer knobs through into the wiring cavity. remove the three spacers on each knob and set aside.
+[* black] If the wires are zip-tied, use wire cutters to cut the tie. This will free up slack in the wires and make removal of later components easier.
+[* icon_caution] Take care to avoid cutting the wires when cutting the zip tie or when moving the wiring later.
+[* black] Pull the pots out into the wiring cavity. Remove the three washers on each knob and set aside.
[* black] Pull the selector switch into the wiring cavity.