crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Marcos Serranocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Marcos Serrano

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Lay the bottom part of the device upside down on a table.
[* red] Locate the four PH1 screw heads on the underside.
-[* black] In our guide, we used the IFIXIT pro tech toolkit. We used the bit driver with a 4mm driver attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
+[* black] We used the bit driver with a 4mm driver(from IFIXIT pro tech toolkit) attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
[* black] ***NOTE***: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is 1cm in diameter and 5cm in depth.