crwdns2933803:04crwdne2933803:0
crwdns2933797:0Paulcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Paul
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Lay the bottom part of the device upside down on a table. |
|---|---|
| + | [* red] Locate the four PH1 screw heads on the underside. |
| + | [* black] In our guide, we used the IFIXIT pro tech toolkit. We used the bit driver with a 4mm driver attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image) |
| + | [* black] ***NOTE***: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is 1cm in diameter and 5cm in depth. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0